Field Setting
General Configuration - IPv4
Method Default value: DHCP assigned (dynamic IP address)
Select Use Static IP Address to configure a static IP address.
Note: When using a static IP address, it is also necessary to
configure other network settings below such as DNS and NTP
settings.
For more information, see also "Recommended Network Con-
figuration" on page116.
IP addr Enter the IP address of the Spectralink IP-DECT/Virtual IP-
DECT Server.
Netmask Enter a new network mask. Contact your system administrator
for more information.
Gateway Enter the IP address of the default gateway.
The default gateway serves as an access point to another net-
work.
Contact your system administrator for more information.
MTU (Maximum Translation
Unit) (Optional)
Enter the size of the largest packet, that your network protocol
can transmit.
General Configuration - IPv6
Method (Optional) Default value:Disabled
If not using IPv4, select Static to set the following settings
manually: IPv6 address, Subnet Prefix Length, Default Gate-
way, Primary DNS Server, and Secondary DNS Server.
Other possible settings are:
l Stateless Address Autoconfiguration (SLAAC): An
IPv6 address is automatically generated based on the
prefix being advertised on the connected network.
l Statefull (DHCPv6): IPv6 address, DNS servers and
DNS search list will be obtained from router.
Address/prefix (Optional) It is possible to enter a prefix (Static IPv6 address with an
optional prefix length).
Address and prefix length must be separated by: /
Default gateway (Optional) Enter IP address of the default gateway. The default gate way
serves as an access point to another network.
To Next Page
Loading...
