Field
Zone based paging (Optional) Zone based paging is used when grouping base sta-
tions into zones in site(s). Not using zones will be sub-
stantial in most average systems.
Note: Zone based paging is built on the DECT Stand-
ard for Location Area Level (LAL).
Note: The field Paging method must be set to Zone
based paging to be able to use zone based paging.
Possible values: 8 Zones (32 base stations per
zone), 16 Zones (16 base stations per zone) or 32
Zones (8 base stations per zone).
Default value: 8 Zones (32 base stations per zone).
For more information about zone based paging, see
"Spectralink IP-DECT Base Station Configuration
Methods - Considerations" on page158. Please read
the information carefully before continuing and ensure
correct deployment of the base stations.
Caution: Assigning RPN's are essential for using
zone based paging, as the RPN decides which zone
the Spectralink IP-DECT Base Station will be part of.
If changing zone size later on after having configured
the base stations and assigned RPN's, then all con-
figuration must be redone. Therefore, consider your
system needs carefully before and when deploying.
Note: Enabling Zone based paging ensures auto-
matic update of handset locations.
For more information about configuration of sites and
zones, see "Configuring Sites (and Zones)" on
page175.
Multicast address (Optional) Multicast address used for signaling.
Default value: 239.255.1.11
Please refer to RFC 2365 and RFC 4291 for details.
Note: Only used with multicast signaling as paging
method.
To Next Page
Loading...
