14215700-IG, Edition 15.0
May 2020, Original document
90
Installing Spectralink IP-DECT Base Sta-
tion
Below you will find information about installing the base station.
Note:
Before you install the equipment, ensure that a site planner defines the location of the
base stations.
Before you begin the installation, determine the position of the base station for best cov-
erage. The average coverage within buildings is 30 meters/100 feet.
The coverage depends on the construction of the building, architecture, and the choice of
building materials.
Power Requirements for the Base Station
The Spectralink IP-DECT Base Station uses:
l Power over Ethernet (PoE 802.3af).
l Maximum power supply consumption is 3.0W (IEEE 802.3af class 1 device).
Use a standard PoE adapter or a PoE-enabled port on a switch adhering to PoE 802.3af when con-
necting the base station to a PoE power source.
Use an 8V-DC power supply when using a port without PoE.
Spectralink IP-DECT Server 200/400/6500 and Virtual IP-DECT Server One Installation and Configuration Guide
To Next Page
Loading...
