14215700-IG, Edition 15.0
May 2020, Original document
181
Assigning Base Stations to Sites
To make use of the created site entities, these must be assigned to the physical base stations. The
devices can be both local and remote.
1. Click Administration, and then click Base Station.
2. On the Base Stations page, click on the relevant base station.
Timesaver:
If you have many base stations that must be assigned to the same site, select all
the relevant base stations, and then select the relevant site from the Assign Site
list. When selected, click OK to confirm.
The base stations are automatically rebooted.
3. On the Base Station page, under General in the Site field, select the desired site:
Field
Base Station - General
IP address (Read only) Current IP address of the base station.
Description (Optional) Enter a description.
It is recommended to use a description of the physical loc-
ation.
RPN Radio Part Number of the base station.
Note: If using zone based paging, assigning base sta-
tions and RPN's are essential, as the RPN decides
which zone the Spectralink IP-DECT Base Station will
be part of. For more information, see "Example of Defin-
ing Sites, Zones and Assigning Numbers to Base Sta-
tions" on page163.
If using radio based synchronization in connection with
zone based paging, RPN's must be assigned to the rel-
evant zones before defining synchronization chain.
Site Default value: None
It is possible to define sites for devices that are located at
the same location.
To assign a site to the base station, select the relevant
site from the list.
For information about defining sites, see "Defining a Site
for the Media Resource and Base Stations" on page177.
Spectralink IP-DECT Server 200/400/6500 and Virtual IP-DECT Server One Installation and Configuration Guide
To Next Page
Loading...
