14215700-IG, Edition 15.0
May 2020, Original document
364
Field Setting
Log TLS keys (Optional) If enabled, TLS master secrets are logged to a log file for
later decryption of TLS in packet capture.
Packet Capture - Status
Status Shows the status of the capture progress.
Current capture size Shows current capture size in kbytes.
3. If you want to start capturing the network packets,click Start, click Stop after trying to repro-
duce the expected failure/behaviour, and then click Save to download and save the packet
capture file.
4. If you want to stream a packet capture, click Stream. A pcap file is downloaded automatically.
Note:
The Spectralink IP-DECT/Virtual IP-DECT Server has a packet capture size limit of 10
megabytes. When this limit is reached, the packet capture will restart. When performing a
streaming packet capture there is no size limit.
Network Diagnose
1. Click Status, and then click Network Diagnose.
2. On the Network Diagnose page, under Host, enter the relevant IP address or domain name:
3. Click Ping to send a ping request to the host to check if network is connected.
4. If you want to trace the route to the host, click Trace route.
Spectralink IP-DECT Server 200/400/6500 and Virtual IP-DECT Server One Installation and Configuration Guide
To Next Page
Loading...
