SpectraLink IP-DECT SERVER 6500 - Radio Based Synchronization; Manual Configuration of Radio Synchronization

14215700-IG, Edition 15.0
May 2020, Original document
189
Radio BasedSynchronization
You define the synchronization chain (sync. chain) of the Spectralink IP-DECT Base Station through
the web based Administration Page of the Spectralink IP-DECT/Virtual IP-DECT Server. Radio syn-
chronization can be done either manually or automatically.
Note:
Automatic configuration of radio synchronization is only supported on systems running
firmware PCS 20B_ or newer.
Note:
If using zone based paging, RPN's must be assigned to the relevant zones before syn-
chronization chain is defined.
Manual Configuration of Radio Synchronization
1. Click Administration, click Base Station, and then click on the relevant base station.
2. On the Base station configuration page, enter the following data:
Field
Base Station - General
IP address (Read only) Current IP address of the base station.
Description (Optional) Enter a description.
It is recommended to use a description of the physical loc-
ation.
RPN Radio Part Number of the base station.
Note: If using zone based paging, assigning base sta-
tions and RPN's are essential, as the RPN decides
which zone the Spectralink IP-DECT Base Station will
be part of. For more information, see "Example of Defin-
ing Sites, Zones and Assigning Numbers to Base Sta-
tions" on page163.
If using radio based synchronization in connection with
zone based paging, RPN's must be assigned to the rel-
evant zones before defining synchronization chain.
Spectralink IP-DECT Server 200/400/6500 and Virtual IP-DECT Server One Installation and Configuration Guide