Field
Site Default value: None
It is possible to define sites for devices that are located at
the same location.
To assign a site to the base station, select the relevant
site from the list.
For information about defining sites, see "Defining a Site
for the Media Resource and Base Stations" on page177.
Disabled (Optional) If enabled, the base station will be disabled.
Note: If Add new as active is enabled (Configuration
> Wireless Server > Base stations), then this will be
unset by default when adding a new base station.
TX power (Optional) Used for controlling the output power for this specific
base station.
Select another value from the list, if you need to change
the output power.
Default value: Default (250 mW). If Frequency is set to
USA, the default value is 100 mW.
Note: If a system TX power other than default is set for
the whole system (Configuration > Wireless Server >
DECT), that setting will override this setting.
External antenna mode
(Optional)
Determines which antenna(s) are used when an external
antenna is connected.
Possible values: Use Internal & external antenna,
Use internal antenna only or Use external antenna
only.
Default value: Use Internal & external antenna
Note: This setting is ignored when no external antenna is
connected.
Note: When using external antenna, the range is
reduced by up to 50 %.
To Next Page
Loading...
