SpectraLink IP-DECT SERVER 6500 - Frequency Swap Support

14215700-IG, Edition 15.0
May 2020, Original document
281
Frequency Swap Support
Note:
Not relevant to the Spectralink IP-DECT Server 200.
Frequency swap support allows the active radio frequency to be changed in accordance to geo-
graphical locations (example: changing from 1.8 GHz to 1.9 GHz, or visa versa).
A Frequency Swap License is required per Spectralink IP-DECT/Virtual IP-DECT Server to be able
to perform the frequency swap. Besides the Frequency Swap License, a special Spectralink DECT
Handset 7212 (part no. 02610004) with a special configuration (and compliance to be compatible
with frequency swap) is also required. For more information about the special handset, see "Hand-
set 7212 Supporting Frequency Swap (Part no. 02610004)" on the next page.
Frequency swap must be configured on the Spectralink IP-DECT/Virtual IP-DECT Server when con-
figuring Wireless Server settings.
On the web based Administration Page of the Spectralink IP-DECT/Virtual IP-DECT Server under
Configuration > Wireless Server > Wireless Server Configuration - DECT, a Frequency field
is visible, when the Frequency Swap License is installed.
The Frequency field contains the following values:
l Europe (EMEA, Australia & NewZealand)
l South America
l USA (USA & Canada)
For more information about configuration of frequency swap, see "Configuring Wireless Server Set-
tings" on page145.
Spectralink IP-DECT Server 200/400/6500 and Virtual IP-DECT Server One Installation and Configuration Guide