Field
Media encryption (SRTP)
(Optional)
If enabled, secure RTP for base station audio con-
nections is used.
Default value: Disabled
Note: If not running PCS 20A_ or newer, this field is
only visible if a Security (TLS, SRTP) License is
loaded.
RFP port range start Port range start for RFP local RTP ports.
Default value: 57000
Note: It is possible to change the value in case of con-
flicting ports.
Paging method (not relevant to
Spectralink IP-DECT Server
200/400)
“Paging” is about incoming voice and messaging calls,
where the Spectralink IP-DECT/Virtual IP-DECT
Server has to send out an announcement (through the
relevant Spectralink IP-DECT Base Stations) asking
the handset to chose a base station and start estab-
lishing a connection.
Possible values: Default, Multicast, Site based
paging, Zone based paging.
Default value: Default
If having more than 256 base stations connected on a
site, default paging is not enough due to the amount of
base stations. In this situation, if multicast signaling is
supported, multicast is the preferred paging method.
Other paging methods are site based paging and zone
based paging.
On a site with heavy voice/messaging load, it is recom-
mended to use Zone based paging instead of using
multicast signaling.
If Multicast is enabled, this will impose multicast sup-
port for the network. For more information, see "Using
Multicast Signaling for Paging" on page161.
Note: For more information about deciding which
paging method to use, see "Spectralink IP-DECT
Base Station Configuration Methods - Con-
siderations" on page158. Please read the information
carefully before continuing and ensure correct deploy-
ment of the base stations.
To Next Page
Loading...
