Field
Multicast TTL (Optional) The TTL is used to limit the propagation of the mul-
ticast packets across routers.
Default value: 1
Note:The TTL is configurable and it is possible to
change the value according to network topology. For
more information, see vendor specific documentation.
Note: Only used with multicast signaling as paging
method.
Default sync type (Optional) This setting controls the default sync type for new
base stations connecting to the server.
Possible values: Free running, Radio or LAN.
Note: Selecting Free running will configure each
base station as a sync master. For more information,
see also Synchronization and Deployment Guide.
Default value: Radio
Note: Multicast address and Multicast TTL are hard-
coded, when selecting LAN. For more information,
see "Using Multicast for LAN" on page188.
LAN sync transport protocol
(Optional)
The protocol transport layer used by PTP for LAN
sync.
Possible values: Ethernet, IPv4 or IPv6.
For more information about using LAN syn-
chronization, see "LAN Based Synchronization
(License Required)" on page194.
To Next Page
Loading...
