1. Click Users, and then click Handset Configuration.
2. Under Handset Configuration Files, do the following:
Field Setting
Handset Configuration Update - Automatic update
Enable (Optional) Default value: Disabled
Enable this, if you want to make automatic update possible.
If enabled and new handsets are added to an existing
uploaded configuration group, these are automatically
updated after subscription has finished. Existing handsets
that are added to a configuration group are also auto-
matically updated.
If a handset configuration update takes place while being in
the menu on the handset, the user must exit menu and then
re-enter before changes are visible.
Note: If using provisioning for uploading the Handset Con-
figuration XML file to the handsets, enabling automatic
update is required. This can be done either through the XML
configuration file or the web based Administration Page. For
more information, see Provisioning Guide.
System load (Optional) Select relevant upload capacity. The load corresponds to the
number of maximum simultaneous updates.
Possible values: Low, Medium or High.
Default value: Medium
Note: If you schedule an upgrade during day hours, you
would typically choose Low to Medium load to avoid any
impact on users. Upgrade after hours typically means no
user load, therefore, you can choose High priority.
Click Save.
Handset ConfigurationīFiles
Configuration Group Information about the Group ID assigned to the user.
E.g.: 100
Version Information about the version of the Handset Configuration
XML file.
To Next Page
Loading...
