14215700-IG, Edition 15.0
May 2020, Original document
298
Field Setting
Redundancy Configuration - Settings
Failover time(sec) Enter value for failover time.
Failure time is the time in seconds from the Spectralink
IP-DECT/Virtual IP-DECT Server detects a failure, until
it initiates a failover operation and cause the other peer to
take over.
Default value: 15 sec
For more information about failure time, see "Failover
time conditions" on page304.
4. Click Save.
Note:
Enabling or disabling the reduncancy funtion on a given server, will not require a
reboot of the Spectralink IP-DECT/Virtual IP-DECT Server(s).
But, after clicking Save, all active calls can be dropped on base stations and media
resources when the function is enabled/disabled as all media resources and base
stations reconnect to the new setup.
Spectralink IP-DECT Server 200/400/6500 and Virtual IP-DECT Server One Installation and Configuration Guide
To Next Page
Loading...
