Field
Allow bearer handovers to repeaters
(Optional) (Not relevant to the Spec-
tralink IP-DECT Server 200/400)
If enabled, bearer handover to repeaters is allowed.
If disabled, handovers between a repeater and base sta-
tion must take place as connection handovers.
Default value: Enabled
Note: If Zone based paging is used, then bearer handover
is not allowed, and this setting is overruled.
Wireless Server Configuration - Media resources (Not relevant to the Spectralink IP-DECT
Server 200/400)
Allow new (Optional) If enabled, new media resources are allowed to connect to
the server.
Default value: Enabled
Add new as active (Optional) If enabled, new media resources will become active when
added. Otherwise they must be activated manually under
Administration > Media Resource > Media Resource
page.
Default value: Disabled
Note: This must be enabled if setting up a redundant sys-
tem using internal media resource.
Require encryption (Optional) If enabled, the connection between the media resource
and the Spectralink IP-DECT/Virtual IP-DECT Server is
required to be encrypted.
Note: Enabling this, will only allow media resources with
firmware PCS 17Fa or newer to connect.
Default value: Disabled
If not enabled, the connection will be encrypted if the
media resource supports encryption.
Wireless Server Configuration - Base stations (Not relevant to the Spectralink IP-DECT
Server 200)
Allow new (Optional) If enabled, new base stations are allowed to connect to
the server.
Default value: Enabled
Add new as active (Optional) If enabled, new base stations will become active when
added. Otherwise, they must be activated manually under
Administration > Base Station >Base Station page.
Default value: Disabled.
To Next Page
Loading...
