SpectraLink IP-DECT SERVER 6500 - Page 380

14215700-IG, Edition 15.0
May 2020, Original document
380
Field
Default sync type (Optional) This setting controls the default sync type for new base sta-
tions connecting to the server.
Possible values: Free running, Radio or LAN.
Note: Selecting Free running will configure each base
station as a sync master. For more information, see also
Synchronization and Deployment Guide.
Default value: Radio
Note: Multicast address and Multicast TTL are hard-
coded, when selecting LAN. For more information, see
"Using Multicast for LAN" on page188.
LAN sync transport protocol
(Optional)
The protocol transport layer used by PTP for LAN sync.
Possible values: Ethernet, IPv4 or IPv6.
For more information about using LAN synchronization,
see "LAN Based Synchronization (License Required)" on
page194.
LAN sync type of service (TOS/Diff-
serv) (Optional)
TOS/DiffServ values can be configured for PTP packets
used for LAN sync. The values are entered in decimal.
Network priority: Packets with higher TOS/DiffServ have
higher priority on the network.
184 = critical (highest priority)
96 = flash
64 = immediate
32 = priority
0 = routine (lowest priority)
Default value: 184 (Expedited Forwarding)
Spectralink IP-DECT Server 200/400/6500 and Virtual IP-DECT Server One Installation and Configuration Guide