Field Setting
Blacklist timeout(sec) Controls the timeout duration for a SIP server to be black-
listed, after loosing connection to the server. After leaving the
blacklist, the server will reattempt to establish connection.
The setting can be set in the range of 5 sec to 600 sec.
Default value: 30 sec
Note: Instead of being a strict timeout, the timeout is con-
sidered loose. This means that the setting guarantees that at
least the specified time will elapse before trying to reconnect.
Thus, more time may elapse, depending on the activeness of
the server, as the timeout is checked at given server SIP activ-
ities.
SIP type of service (TOS/Diffserv) TOS/Diffserv used for SIP signaling. Entered in decimal.
Default value: 96 (AF - Assured Forwarding)
SIP 802.1p Class-of-Service This is the 802.1p PCP and must be between 0 and 7. The
setting requires VLAN tagging.
Default value: 3
GRUU (Optional) If enabled, Globally Routable User Agent URIs are sup-
ported.
Default value: Enabled
Use SIPSURI (Optional) Normally, SIP communication on a TLS connection uses the
SIPS: URI scheme.
Disabling this option causes the Wireless Server to use the
SIP: URI scheme with a transport=tls parameter for TLS con-
nections.
Default value: Disabled
TLS allow insecure (Optional) By default, UDP and TCP transports are disabled when TLS
transport is the default. If this setting is enabled, UDP and
TCP are allowed as fallback if TLS fails.
Default value: Disabled
TCP ephemeral port in contact
address (Optional)
If enabled, the TCP ephemeral port (the local TCP port of the
outgoing connection) to the contact header, used in outgoing
SIP messages, is added.
To Next Page
Loading...
