SpectraLink IP-DECT SERVER 6500 - Page 412

14215700-IG, Edition 15.0
May 2020, Original document
412
Field
External antenna mode (Optional) Determines which antenna(s) are used when an external
antenna is connected.
Possible values: Use Internal & external antenna, Use
internal antenna only or Use external antenna only.
Default value: Use Internal & external antenna
Note: This setting is ignored when no external antenna is con-
nected.
Note: When using external antenna, the range is reduced by
up to 50 %.
Base Station - Synchronization
Type This setting controls the synchronization type used for the
specific base station/DECT radio.
Possible values: Free running, Radio, LAN or Radio/LAN
Gateway.
Select Free running, if you want to configure this base sta-
tion as sync master. Otherwise select either Radio, LAN or
Radio/LAN Gateway, depending on the synchronization
method.
Default value: Radio
Note: Automatic configuration of radio synchronization is sup-
ported on systems running firmware PCS 20B_ or newer.
For more information, see "Automatic Configuration of
RadioSynchronization" on page192.
Note: To be able to select LAN or Radio/LAN Gateway,
aquisition of a LAN Synchronization License is required.
Note: System wide settings for synchronization are located
under Configuration > Wireless Server > Base stations.
For more information, see Synchronization and Deployment
Guide.
Auto radio sync (deployment only)
(Optional)
If enabled, the base station will be auto synchronized while
deploying the system.
Note: This must only be used while deploying the system.
Primary radio sync (RPN)
(Optional)
RPN identifying the base station used for primary radio syn-
chronization.
Secondary radio sync (RPN)
(Optional)
RPN identifying the base station used for secondary radio
synchronization.
Spectralink IP-DECT Server 200/400/6500 and Virtual IP-DECT Server One Installation and Configuration Guide