Spectroquant Pharo 300 - Page 109

Spectroquant
®
Pharo 300 Operation
109
ba75703d07 04/2014
Create all required procedure vari-
ables.
5 Create a procedure variable
required for the formula with [Add]
and enter a designation, e.g. the
measured parameter.
or
Using [Next], accept all entries on
the page and switch to the next
page.
6 Add another procedure variable
with [Add].
or
Delete a highlighted procedure
variable with [Delete].
7 Using [Next], accept all entries on
the page and switch to the next
page.
Enter the formula.
8 Enter any numbers with <0...9>.
Use [Operators] , <▲><▼>
<><> and <START ENTER>
to enter an operator, a function or
a constant.
Use [Variables], <▲><▼>
<><> and <START ENTER>
to select a variable.
The formula is displayed after
each step.
Using <> you can delete the last
element of the formula.
Use [Back] to quit the formula edi-
tor.
Procedure variables
16.04.07 9:52
Procedure variables are variables whose current numerical
values have to be entered during the course of the
measurement (e.g. weighted sample or dilution). If a
procedure variable is required to calculate the result: Create a
procedure variable (K) with <Add>.
Back Add Next
Procedure variables
16.04.07 9:52
K 1 V (extract)
K 2 V (sample)
Back Add Delete D Next
Formula entry
16.04.07 9:52
Use the <Operators> softkey to select an operation, function
or constant (e.g.: +, -, *, tan, log, e, Pi). Use the <Variables>
softkey to select an absorbance at a certain wavelength or a
procedure variable. Enter numerals via the keyboard. You can
erase the last entry with <?>.
Back Operators Variables Next