Operation Spectroquant
®
Pharo 300
136
ba75703d07 04/2014
Scaling of the Y-axis You can manually determine the scaling of the Y-axis with [Setup]/Scaling/
Manual.
Compare kinetics For direct comparison, you can load a second kinetic record into the same
diagram with [Edit] / Compare kinetics.
Note
The Compare kinetics function can only be carried out if both kinetic records
were made in the Absorbance mode.
Subtract kinetics You can subtract a stored kinetic record from the current kinetic record with
[Edit] / Subtract kinetics.
Note
The Subtract kinetics can only be carried out if both kinetic records were
made with the following settings:
Mode: Absorbance
Measurements/interval:1/interval
Equal interval
Measurements/interval Slope
1/interval Slope,
converted to the interval, "1 minute"
Max/interval Slope of the straight line determined by linear
regression in an interval, converted to the inter-
val, "1 minute"
To Next Page
Loading...