Sprinte ASP 116 evolution - Power Supply; Identification

USER MANUAL « ASP 116 EVOLUTION »
CONFIGURATION
Sprinte SAS, All rights reserved, including translation rights
16
2.8 Power supply
SETUP ► POWER SUPPLY
PHASE CONTROL
Detection of phase inversion or failure
[NO DETECTION] [DETECTION]*
2.9 Identification
CONFIGURATION ► IDENTIFICATION
CLIENT
Name of client
Name of company
[16 characters]
REFERENCE
Reference name
Lift address where control panel is installed
[16 characters]
SERIAL NUMBER
Control panel serial number
[YYMMXXX] YY : Year of manufacture MM : Month of manufacture
XXX : Number in the month
SIMPLEX NUMBER
Multiplex lift number
[1*..4] In multiplex each lift must have a separate number
LIFT MARK
Serial lift number displayed in car
N° [16 characters]
CE MARK
CE mark displayed in car
[XXXX]
CONSTRUCT.YEAR
Construction year of the lift
This construction year will be displayed next to the CE mark on the load plate of the
236SP1 display.If the year is set to 0, nothing will be displayed.
[XXXX]