Sprinte ASP 116 evolution - Frequency Inverter Settings

USER MANUAL « ASP 116 EVOLUTION »
CONFIGURATION
Sprinte SAS, All rights reserved, including translation rights
20
2.12 Frequency inverter settings
CONFIGURATION ► FREQ. INVERTER
Some information like speed, motor current, output frequency, power supply of the inverter are available in this
menu :
DIAGNOSTIC ► INVERTER
Warning, to modify the parameters of the inverter, it is necessary to have :
PROTECT. MENU VF = NON PROTEGE
MENU VF PROTECT.
Protection du menu variateur
[PROTECTED]*
In this mode, you only can read the inverter configuration. The parameter goes
automatically in PROTECTED mode at midnight to avoid wrong manipulation.
[NO PROTECTED]
Put the parameter to «NO PROTECTED” to be authorized to modified the inverter
parameters
LIFT DATAS
Information of the lift
Press « ENTER » to go in the menu
MOTOR DATAS
characteristics of the motor
Press « ENTER » to go in the menu
ENCODER DATAS
characteristics of the encoder
Press « ENTER » to go in the menu
SPEED LOOP
Speed loop optimisation
Press « ENTER » to go in the menu
ROLLBACK
Rollback management
Press « ENTER » to go in the menu
BRAKE
Adjustment of the starting to stopping of the brake
Press « ENTER » to go in the menu
ASYNC. OPTIMIZ.
Asynchronous motors optimisation
Press « ENTER » to go in the menu
INSPECTION MODE
inspection mode parameters
Press « ENTER » to go in the menu
NOISE LEVEL
Noise reduction
Press « ENTER » to go in the menu