Sprinte ASP 116 evolution - Re-levelling Operation

USER MANUAL « ASP 116 EVOLUTION »
CONFIGURATION
Sprinte SAS, All rights reserved, including translation rights
31
2.14 Re-levelling operation
SETUP ► LEVELLING
LEVELLING
LEVELLING OPERATION
Maintaining the car at landing level with doors open. This function is deactivated in call
or inspection mode . Connector CB10 / 211SP
[NO]
No levelling is done if the car drifts in door area. Only forced closing of doors if the car
exits the door area
[YES]
In case of drift while parking, the car is re-levelled with doors opened thanks to
activation of security relay. Movement is done at low speed with spring cam.
LEVELLING TIME
Maximum levelling time
This is the maximum time to regain level in case of car backstop. If the car has not
regained its level within this time, a fault “LEV. TOO LONG” is given.
[05..30] seconds
LEVELLING CT
Levelling counter
A limited number of levellings is authorised on the landing. A fault “LEV REPEATED” is
activated if the threshold is exceeded.
[5..15]
LEVELLING TPO
Maintaining time of levelling.
Once the floor is reached, the levelling movement is maintained during the value of this
temporization. With a very accurate motor (no slip), the car could stop beneath the
floor. This can be solved with this parameter
[5..15] seconds (0s default value)