MANUEL D’UTILISATION « ASP 116 EVOLUTION »
Sprinte SAS, All rights reserved, including translation rights
4.4 Faults list
Pressing the “ENTER” key gives the number of faults recorded than pressing on the “ “ or “” keys scrolls through
the list of recorded faults.
Pressing and holding down the “ENTER” key on a fault gives the day, time and floor where the fault appeared.
To delete the faults list, scroll through the faults list until you get to “DELETE FAULTS?” Then press the “ENTER”
key
Type of faults:
(OOM) OUT OF ORDER MAINTENED: The lift is out of order, only intervention by a technician can put it
back in service. You have to delete the faults in the diagnosis menu to get the Lift back in user mode.
(OO) OUT OF ORDER: The lift is out of order, when the fault disappears the lift goes back in service.
ALARM: The control panel indicates a minor fault but the lift remains in service.
The lift goes into emergency mode, all commands in progress are stopped.
- Check the input voltage
- Check fuses on “PFS1” fuse and position of “PFS1” micro-circuit breaker
- Check T380, T0, V24 fuses on 104SP power supply board
Absence or reversal of phases (EDF mains supply)
Detection of this fault can be deactivated by the configuration menu
Reverse phases L1, L2, L3 and check voltage between each phase on control panel’s input terminal block.
The car lighting is out of order
The car is illuminated by emergency lighting. Check car lighting power supply. The car goes to the destination
floor and goes out of service
- The 211SP board LCP LED and the 212SP board D2 LED must be ON, check the 212SP board’s LCP
fuse
To Next Page
Loading...
