StarCraft SOLO with CREATE 1.008
January 18, 2022 Version
Please use the following steps as a guide to set up and begin successfully using your new SOLO:
Step 1: Unpack your SOLO and verify nothing is missing (Sections 1.01 and 1.04).
Step 2: Note the names of various parts of your SOLO for future reference (Section 1.05).
Step 3: Install the CREATE software and register it (Section 1.06).
Step 4: Power on the SOLO and note the basic settings on the control panel (Section 1.07).
Step 5: Connect the SOLO to your computer after reviewing the connection options (Section 1.08).
Step 6: Check out the other accessories which came with your SOLO (Section 1.09).
Step 7: Adjust the pinch rollers to their proper positions (Section 1.10).
Step 8: Practice drawing a shape using the test pen (Section 1.11).
Step 9: Understand some important factors and settings before cutting with the blade holder (Sections
2.01 – 2.04).
Step 10: If you plan to perform Print+Cut applications (aka contour cuts), calibrate the camera and
set up your first project (Sections 3.02 and 3.03).
Step 11: Some of the more commonly used CREATE functions are presented in Chapter 4. A
complete StarCraft CREATE User Manual can be found at the link below. Note that references in blue
here in this manual pertain to the CREATE manual.
Step 12: Appendix A is a troubleshooting section for issues involving communication, operating,
cutting, and the CREATE software. Appendices B – E contain advanced topics that you may or may
not ever need.
Latest Update to StarCraft SOLO Manual: https://tinyurl.com/pbmam6eu
Latest Update to StarCraft CREATE User Manual: https://tinyurl.com/46wnn3ck
_____________________________________________________________
© 2021, 2022 starcraftvinyl.com All Rights Reserved
To Next Page
General