Starcraft SOLO - Parts of the solo Cutter

7
1.05 Parts of the SOLO Cutter
Front
• Alignment Arrows: indicate to the user the available positions for the pinch wheels
• Blade Carriage: moves the Blade Holder Seat left and right
• Blade Holder Seat (Jaw or Clamp): holds the blade holder, test pen, and other accessories
• Control Panel: used to change settings, set up Wi-Fi, calibrate camera, cut PLT files, and more
• Cutting Strip: protects a blade when cutting backed materials without using a cutting mat
• Grit Shafts (total of 3): allow the pinch wheels to grip the mat or material so they can be moved in and out of
the cutter during cutting
• Pinch Wheel (Roller) Assemblies (total of 3): grip the mat or material so that the grit shafts beneath will feed
the mat or material in and out during cutting
• Power Button: turns cutter on and off
Right Side
Power Port
USB Flash
Drive Port
USB Port
Pinch Wheel Lever
Alignment Arrow
Pinch Wheel or
Pinch Roller
Control Panel
Left
End Cap
Right
End Cap
Power Button
Blade
Carriage
Cutting Strip
(white)
Grit Shaft (dark
gray and rough)
Blade Holder Seat
(aka Jaw)
• Pinch Wheel Lever: move down to lift the pinch wheels
up for loading the mat or material and move up to lower
the pinch wheels for cutting
• USB Flash Drive Port: used to load PLT files via the
control panel for cutting
• USB Port: option to connect computer to the SOLO with
included USB cable
• Power Port: connect the SOLO’s power adaptor