Sun Microsystems SPARCstation 5 - Figure 9-9 Disengaging the Diskette Drive

9-12 SPARCstation 5 Service Manual—November 1996
9
4. Remove the diskette drive filler panel (if present) in the same way as you
remove the CD-ROM filler panel, as shown in Figure 9-8. If the diskette
drive is installed, push the diskette drive toward the center of the chassis
to disengage it.
Do not push on the drive’s front bezel. You may need to use a screwdriver
for leverage. Use the screwdriver to push on the drive grommets as shown
in Figure 9-9.
Figure 9-9 Disengaging the Diskette Drive