FORTH Diagnostics D-3
D
4. Enter n at the > prompt to get to the ok prompt.
5. Enter reset at the ok prompt.
6. When you see the system banner, press Stop-a to access the
FORTH Monitor.
7. If you see the > prompt, enter n to get to the ok prompt.
8. Enter help diag at the ok prompt to get a list of tests that comprise
the FORTH Diagnostics.
9. Enter the name of the test that you wish to execute.
Figure D-1 shows a list of FORTH Diagnostic tests.
Figure D-1 Displaying FORTH Diagnostics
ok help diag
Category: Diag (diagnostic routines)
test device-specifier ( -- ) run selftest method for specified device
Examples:
test /memory - test memory
test /iommu/sbus/ledma/le - test net
test floppy - test floppy disk drive
test net - test net (device-specifier is an alias)
test scsi - test scsi(device-specifier is an alias)
watch-clock (--) show ticks of real-time clock
watch-net (--) - monitor broadcast packets using auto-selected interface
watch-aui (--) - monitor broadcast packets using AUI interface
watch-tpe (--) - monitor broadcast packets using TPE interface
watch-net-all (--) - monitor broadcast packets on all net interfaces
probe-scsi (--) - show attached SCSI devices
probe-scsi-all (--) - show attached SCSI devices for all host adapters
test-all (--) - execute test for all devices with selftest method
test-memory (--) - test all memory if diag-switch? is true, otherwise test memory
specified by selftest-#megs
To Next Page
Loading...
