Sun Microsystems SPARCstation 5 - Figure 7-5 Securing the System Unit Cover

7-6 SPARCstation 5 Service Manual—November 1996
7
3. Replace the lock block on the rear panel. Tighten the Phillips screw that
secures the lock block to the cover.
See Figure 7-5.
4. Tighten the captive Phillips screw in the upper-right corner of the
rear panel.
See Figure 7-5.
Caution – Do not use a power driver to tighten captive screws. Do not
overtighten captive screws.
Figure 7-5 Securing the System Unit Cover
!