Sun Microsystems SPARCstation 5 - Figure 11-2 Opening the Sbus Card Retainers; Figure 11-3 Removing the Extractor from the Sbus Card

System Board and Component Replacement 11-3
11
Figure 11-2 Opening the SBus Card Retainers
4. Remove the SBus card extractor from the replacement SBus card:
a. Bend one leg of the extractor slightly to the outside until the hook
clears the hole in the SBus card.
See Figure 11-3.
b. Remove the other side of the extractor, which should come out easily
without bending it.
Place the replacement SBus card on an antistatic surface.
Figure 11-3 Removing the Extractor From the SBus Card
Push back both
card retainers.
SBus card
extractor
Replacement
SBus card