8-6 SPARCstation 5 Service Manual—November 1996
8
5. The LED is located at the shrink-wrapped end of the speaker/LED cable.
Using the tip of a small, flat-blade screwdriver, work the cable and LED
free from the plastic tabs that hold them in place.
See Figure 8-3.
6. Disconnect the speaker/LED connector from the system board.
See Figure 8-3.
Figure 8-3 Speaker/Power LED Cable Connections
7. Carefully free the speaker/LED harness from the card guide cable clips,
and lift the harness out of the system chassis.
Speaker/LED
cable connector
Power LED
Speaker cable
connectors
Card guide cable clips
on chassis floor
Metal cable clips
To Next Page
Loading...
