Sun Microsystems SPARCstation 5 - CD-ROM Audio Cable

Storage Devices 9-29
9
3. Install the diskette drive.
See Section 9.3.2, “Replacing the Diskette Drive.”
4. Install the CD-ROM drive (if necessary).
See Section 9.2.2, “Replacing the CD-ROM Drive.”
5. Detach the wrist strap and replace the cover.
See Chapter 7, “Internal Access.”
6. Power on the system.
See Section 6.2, “Powering On the System.”
9.7 CD-ROM Audio Cable
9.7.1 Removing the CD-ROM Audio Cable
1. Shut down and power off the system.
See Section 6.1, “Powering Off the System.”
2. Remove the cover and attach a wrist strap.
See Chapter 7, “Internal Access.”
3. Disconnect the CD-ROM audio cable from the CD-ROM drive.
See Figure 9-25.
Figure 9-25 Audio Cable Connector on the CD-ROM Drive
CD-ROM audio
cable connector