9-14 SPARCstation 5 Service Manual—November 1996
9
9.3.2 Replacing the Diskette Drive
1. Remove the new diskette drive and its related parts from the antistatic
bag, and place them on an antistatic surface.
Read the diskette drive specifications sheet for related installation
information.
2. Hold the diskette drive in one hand, and lower it far enough into the
chassis to connect the cables to the back of the drive.
3. Attach the diskette data cable and the DC power cable (labeled P4)
to the drive connectors.
See Figure 9-11.
4. Lower the drive grommets into their corresponding slots in the side rails,
and slide the drive until it is fully secured in the bracket.
See Figure 9-11.
5. Install the diskette drive outer filler panel by inserting the bottom tabs
into the corresponding slots in the chassis, and rotating the panel upward
into position.
To Next Page
Loading...
Need help?
General
