Storage Devices 9-31
9
2. Connect the CD-ROM audio cable to the system board.
See Figure 9-26.
3. Connect the CD-ROM audio cable to the audio connector on the
CD-ROM drive.
See Figure 9-25.
4. Reinstall the SBus card (if necessary).
See Section 11.1.2, “Replacing an SBus Card.”
5. Detach the wrist strap and replace the cover.
See Chapter 7, “Internal Access.”
6. Power on the system.
See Section 6.2, “Powering On the System.”
To Next Page
Loading...
