C-1
SCSI Targeting
C
This appendix describes the SCSI targeting for the internal SCSI devices in the
SPARCstation 5 system. It also describes the SCSI targeting conventions for
external SCSI peripherals that you can add to the system. For complete SCSI
target information about SCSI peripherals, see the installation manual that
came with the SCSI peripheral.
Note – Assign each SCSI device on the SCSI chain a different SCSI target.
Each internal SCSI disk drive present in a SPARCstation 5 system is
automatically assigned a SCSI target (see Table C-1 and Table C-2); these
targets are only assigned if the device is present. When assigning SCSI targets
to external devices, make sure that none of the external targets conflict with
targets automatically assigned to the internal disk drives.
Note – SCSI termination for internal drives is provided automatically by the
SCSI backplane.
SCSI target 7 is reserved for the SCSI processor of the computer system or the
SCSI host adapter card.
To Next Page
Loading...
Need help?
General
