Suzuki LT-Z400 2003 - BREAK-IN PROCEDURES

H GENERAL INFORMATION
BREAK-IN PROCEDURES
During manufacturing only the best possible materials are used and all machined parts are finished to a very
high standard.
It is still necessary to allow the moving parts to "BREAK·IW before subjecting the engine to
maximum stresses. The future periormance and
reliability of the engine depends on the care and restraint
exercised during its early
life. Refer to the following break-in engine speed recommendations .
• Keep to these breake-in engine speed limits.
Break·ln engine speeds
Initial 1 0 hours : Less than Y2 throttle
• After the engine has been operated for 10 hours the engine to full throttle operation, for short periods of
time.