~
CHA
SS
IS
• Remove the connector
r:/)
and O-ring @ by removing the snap
ring
®.
• Remove the dust boot
®l.
• Remove the snap ring ®.
• Remove the push rod @. piston/primary cup @ and spring
$.
MASTER CYLINDER INSPECTION
MASTER CYLINDER
Inspect the master cylinder bore for any scratches
or
damage. If
any damages are found, replace the master cylinder with a new
one
.
PISTON
AND
RUBBER
PARTS
Inspect the piston surface, primary cup, secondary cup and dust
boot for any scratches, wear or damage. If any damages are
found, replace them with a new one.
o
~
~I
O
o
o
To Next Page
Loading...
