Suzuki LT-Z400 2003 - Remounting; Suspension Setting

REMOUNTING
Remounting the rear shock absorber in the reverse order of
removal. Pay attention to the following point s:
• Tigten each bolt/nut to the specified torque.
~ Re ar shock absorber nut (Upper) G) :
60 N·m (6.0 kgf-m. 43.5 Ib·lt)
Rear shock absorber nut (Lower) ~ :
55 N·m (5.5 kgf -m. 40.0 Ib-It)
Rear cushion rod nut @: 78 N·m (7.e kgf -m. 56.5 Ib-ff)
SUSPENSION SETTING
SPRING PRE-LOAD ADJUSTMENT
The rear suspension spring pre-load is adjustable. This adjust-
ment is performed by changing spring set length.
SPRING SET LENGTH
MAXIMUM MINIMUM
STANDARD
(SOFTEST)
(STIFFEST)
233mm 238m m
228.5 mm
(9 .17 in) ( 9. 37 in)
( 9.00 in)
I CAUTION I
Do not set the s pring length out of the specified range.
• Remove the rear shock absorber. (c:::76-62)
•
Loosen the locknut CD.
• Adjust the spring set length by turning the adjuster ~.
• Tighten the locknut CD to the specified to rque.
~ Rear shock absorber locknut :
88 N·m (8.8 kgf-m . 63.5 Ib-It)
• Remount the rear shock absorber. (c::7'above)
CHASSlS 6-6 5