ENGINE REASSEMBLY
Reassemble the engine
in
the reverse order of disassembly.
Pay special attention to the following points:
NOTE:
Apply
engine oil
to
each running and sliding part before reas-
sembling the engine.
CRANKSHAFT
<D
Bearing
(2)
Crankshaft (A)
@ Conrod
@ Bearing
CSl
Crank
pin
® Crankshaft (L)
(J)
Bearing
• Determine the width between the webs referring to the figure
when rebuilding the crankshaft.
_
Crank~web-to-web-width
Standard: 62.0 • 0.1
mm
(2.441 • 0.004 In)
•
When mounting the crankshaft in the crankcase, it is neces-
sary to pull its left end into the crankcase by using the special
tools.
di:I
09910-32812:
Crankshaft
Installer
09910-32820:
Spacer
09911-11310:
Attachment
~~~
-------,
Never
fit
the
crankshaft
Into
the
crankcase
by
striking
it
with
a
plastic
hammer.
Always
use
the
special
tool
,
otherwise
the
accuracy
01
the
crankshaft
alignment
will
be
affected.
ENGINE
3-47
L
f-
-
~
To Next Page
Loading...
