6-18
CHASSIS
BRAKE PAD REPLACEMENT
• Remove the front wheel. 0
:::7
6-10)
•
Remove the brake caliper mounting bolts
CD
and brake pad
mounting pins
(2).
• Remove the brake pads.
I CAUTION I
•
Do
not
operate the brake lever
during
or
after brake
pad
removal.
* Replace the brake pads as a set,
otherwise
braking
performance will be adversely affected.
• Install the new brake pads.
NOTE:
* Before installing the new pads, inspect the pad mounting pins
for wear.
If
excessive wear is found, replace them with new
ones .
..
The shim
must
be installed to the calipe piston side
pad
.
..
Make sure that the detent
of
pad ;s fitted to the detent on the
brake
caliper
holder.
• Tighten
the
brake pad
mo
unting pins @ and brake caliper
mounting bolts @ to the specified torqu
e.
[!J
Brake pad
mounting
pin: 18 N·m
(1
.8 kgf-m, 13.0 Ib-ft)
Brake caliper
mounting
bolt
:
26 N·m
(2
.6 kg!·m. 19.0 Ib-It)
NOTE:
After replacing the brake pads, pump the brake lever several
times to check for proper brake operation and then check the
brake fluid level.
To Next Page
Loading...
