4-14
FUEL
SYSTEM
VALVE SEAT
• Instatl
the valve seat
<D
into
the
carburetor body, and then
tighten the screw
<Zl.
NO
TE
:
Make sure that the coffar
of
the screw
<2>
holds the step
of
th
e
valve seat
(j)
securely.
DIAPHRAGM
•
In
stall the diaphragm assembly and O-ring
(1).
NOTE:
When installing the diaphragm, make sure the diaphragm is
seated
at
the concave section
of
the carburetor.
I CAUTION I
Replace the removed
a-ring
with a
new
one.
THROTTLE STOP SCREW
•
Apply SUZUKI SUPER GREASE "A" to thread part of the
throttle stop screw, then install
the
throttle stop screw to the
carburetor .
.0
99000·25030: SUZUKI SUPER GREASE " A" (USA)
99000·25010: SUZUKI SUPER
GREASE " A" (Others)
REMOUNTING
Remount the carburetor assembly
in
the reverse order of
removal. Pay attention to the following points:
10
Align the lug on the carburetor with the intake pipe's cutout.
• Connect the carburetor hoses properly.
(c::r8-15)
After the carburetor assembly has been remounted onto the
engine, perform
the
following adjustments:
• Throttle cable play ........................................
t:7
2-11
• Engine idle speed ................ , ........................
c::r2-
11
To Next Page
Loading...
