6-92
CHASSIS
• Remove the engine sprocket cover. (c::7'3-5)
•
Disconnect the cable by removing the cable mounting bolt.
REMOUNTING
Remount the reverse lock release cable
in
the reverse order
removal.
Pay
attention to the following points:
• Install the spring with the spring end ® matched the groove
@ on the housing.
• Apply SUZUKI SUPER GREASE "A" to the O-ring
<D
.
.0
99000-25030: SUZUKI SUPER
GREASE
"A"
(USA)
99000-25010: SUZUKI SUPER
GREASE
" A"
(Others)
•
InstaU
the O-ring
CD
to the reverse lock release cable
<%I.
• Connect the cable to the rotor @ through the hole of the hous-
ing.
NOTE:
*
When
installing
the
rotor, hook the spring end © on the con-
cave portion @
of
the
rotor
.
• Make sure that
the
reverse lock release cable is routed cor-
rectly.
To Next Page
Loading...
