TOE-IN ADJUSTMENT
Adjust the toe-in as follow
s:
• Place t
he
vehicle on level ground and set the handlebars
straight.
Make sure all
the
tires are inflated to the standard pressure.
(c:72-20)
• Place 75
kg
(165 Ibs)
of
weight on the seat.
• Loosen the locknuts (
<D,
~
)
on each tie rod.
ICAUTION I
I The
locknuts
<2>
hav
e left-
hand
threads.
• Meas
ur
e the distances (® and @) between the front wheel
s.
Subtract the measurements of ® from the measurements
of
@ to find the toe-in. If the toe-in
is
not within specification,
adjust the tie rod to the right
or
left until the toe-in
is
within the
specified range.
®
-@=Toe-in
B Toe-
In
Standard: 5 ± 4
mm
(0.
20
± 0.16 in)
• Temporarily tighten the four locknuts.
• Check that
the
distances (© and
@)
are equal, as shown. If
the distances are not equal, adjust the tie rod
to
the right or
left until the toe-
in
is within specification. Check the toe-in
again by measuring distances
® and
@.
• If the toe-in is not within specification, repeat
the
adjustment
as above
un
til Ihe proper loe-in is obtained and distances ©
and @ become equal.
•
After adjustment has been made, tighten the
fou
r locknuts
CD
to the specified torque.
t!l Tie
rod
locknu!
: 29 N·m (2.9
kgf-m
o
21
.0
Ib-ft
)
C
HA
SSIS
~7
(j)
(2) (2)
(j)
~
y
~
..
'
<><warn
®
/
---.,
,r
'"
0
>t-
o
,
~
0
'--
Alghl~
'--
J J V 190'".)
1-
- ©
@-
Forward
To Next Page
Loading...
