Suzuki LT-Z400 2003 - Primary Drive Gear and Balancer Gear

PRIMARY DRIVE GEAR AND BALANCER
GEAR
• Install the pins <D.
• Install the balancer drive gear ~.
• Install the key @ and cam chain drive sprocket @.
• Apply engine oil to the thread and inside surface of the nut.
• Hold the generator rotor using a 27-mm offset wrench, and
then tighten the primary drive gear nut to the specified torque.
~ Primary drive gear nut: 140 N·m (14.0 kgf-m. 101 .5 Ib-It)
NOTE:
This nut has left-hand thread.
ICAUTION I
Apply engine all to the primary drive gear nut.
• Install the balancer driven gear @ by aligning the matching
marks @,
• Hold the generator rotor using a 27·mm offset wrench, and
then tighten the
ba lancer driven gear nut to the specified
torque.
~ Balancer dr iven gear nut: 50 N·m (5.0 kgf-m, 36.0 Ib-ft)
ENGINE 3-51