7·26
E
LEC
TRI
CAL
SYS
T
EM
BATIERY
SPECIFICATIONS
Type designation
YTX9·BS
Capacity
12V.
28
.8
kG
(8
Ah
)l
10HR
fa'
Anode plates
@ Separator (fiberglass plate)
© Cathode plates
@
Upper cover
breather
@ Stopper
lD
Filter
® Termlnal
® Salty vallie
INITIAL CHARGING
FILLING
ELECTROL
VTE
• Remove the aluminum tape
<D
which seals the battery filter
holes
(2).
• Remove the caps @ from the electrolyte container.
NOTE:
•
Do not remove
or
pierce the sealed areas @
of
the electrolyte
container.
• After completely filling the battery with electrolyte, use the caps
~
from the electrolyte container
to
seal the battery filler holes.
• Insert the nozzles of the electrolyte container @ into the elec-
trolyte filler holes of the battery. Hold the electrolyte container
firmly so that
it
does not fall. Do not allow any
of
the electro-
lyte
10
spill.
• Make sure the
air
bubbles
<D
rise to the top of each electrolyte
container and leave the electrolyte container
in
this position
for more than
20 minutes.
To Next Page
Loading...
