STARTER CLUTCH
• Hold the rotor using a 27-mm offset wrench and remove the
bolts.
• Install the starter clutch in the proper direction as shown.
NOTE:
When installing the starter clutch onto the rotor, make sure that
the flange side ®
in
the bearing faces to the rotor.
• Apply engine oil to the starter clutch.
• Tighten the bolts while holding the rotor using a 27 -mm offset
wrench.
• Install the starter gear
<D
to the starter clutch.
• Check that the rotor
(2)
turns in the direction of the arrow @ on
the rotor while holding the starter gear, and that t
he
rotor
never turns in the opposite direction
of
the arrow.
EN
GI
NE
3-35
•
•
•
To Next Page
Loading...
