6-16
CHASSIS
NOTE:
•
For
inspecting the lire, refer
to
page 2-20.
• Inspect the valve core, before installation.
• When installing the fronf tire, make sure that the arrow ® on
the side wall
of
the front tire points in the direction
of
rotation.
• When installing
the
rear tirs, make sure that the instruction
"SIDE FACING
INWARDS"@on
the rear tire faces inwards.
• Inflate the tire to seat the tire bead.
em
Maximum
tire
bead seat p
ressure
Front:
250 kPa (2.5 kgllcm', 36 psi)
Rear :
250 kPa (2.5 kgllcm
',
36 psi)
r:1
C'"'A
""
U
"'
T'"'IO'"'N
""I
Place the tire under a protective tire cage
or
similar
protective covering device before Inflating the tire. To
minimize the
possibility
of
tire damage when seating
the
tire bead,
never
exceed the MAXIMUM TIRE
BEAD
SEAT PRESSURE rating
shown
on
the tire.
NOTE:
Check the "rim line"
<D
cast
on
the tire side walls. It
must
be
equidistant from the wheel rim
all the way around.
If
the distance
between the rim
line and the wheel rim varies
th
is indicates that
the bead
is not properly seated.
If
this is so, deflate the tire com-
pletely,
and
unseat the tire bead
on
both sides. Then, coat the
bead with clean water,
and
re-seat the tire.
• Adjust the tire pressure to the specification. (c:::7'2-20)
ICAUTION I
Before
Inflating
the tire,
check
the MAXIMUM OPER-
ATING PRESSURE
rating
of
the
tire.
This
Is
Indicated
by
a "te"
following
the tire size
shown
on
the
sidewall.
The
number
of
"te" on
the
tire
Indicates
the
maximum
operating
pressure
.
~
Maximum
operating
pressure
t",,: 35 kPa (0.35 kgflcm
',
5.1
psi)
To Next Page
Loading...
