Suzuki LT-Z400 2003 - Page 219

SWINGARM BEARING AND BUSHING
Insert the spacer CD into the bearing ~, bushing @ and then
check the play when moving the spacer up and down.
If excessive play is noted, replace the bearing and bushing with
a new one.
• Remove the dust seals.
•
Remove the pivot bearings with special tools.
irQ. 09923 ~ 74511: Bearing remover
09930-30104: Sliding shaft
I CAUTION I
The removed bearings must be replaced with new
ones.
• Remove the pivot bushing with special 1001.
mi:l 09913-70210: Bearing installer set
The removed bushings must be replaced with new
ones.
<D"
P)
I
CHASSIS 6-71
@
.
.
If%!
If