Suzuki LT-Z400 2003 - Page 7

GENERAL INFORMATION 1-3
I CAUTION I
• If parts replacement Is necessary, replace the parts with SUZUKI Genuine Parts or their equiv-
alent.
• When removing parts that are to be reused, keep them arranged in an orderly manner so that
they may be reinstalled in the proper order.
* Be sure to use special tools when Instructed.
• Make sure that all parts used in reassembly are clean. Lubricate them when specified.
* Use the specified lubricants , bonds , or sealants.
* When removing the battery, disconnect the e battery lead wire first , then the (£J battery lead
wire.
• When reconnecting the battery, connect the ® battery lead wire first , then the e battery lead
wire. Finally,
cover the ® battery terminal with the terminal cover.
* When performing service to electrical parts , disconnect the 8 battery lead wire , unless the
service
procedure requires the battery power .
" When tightening cylinder head and crankcase nuts and bolts, tighten the larger sizes first.
Always tighten the nuts and bolts from the inside working out , diagnoally and to the specified
torque .
* Whenever you remove oil seals, gaskets, packing , O-rings, self - locking nuts, locking wash-
ers, cotter pins, circlips , snap rings and other specified parts, be sure to replace them with
new ones . Also , before installing these new parts , be sure to remove any left over material
from the mating surfaces.
* Never reuse a circlip and snap ring. When Installing a new snap ring , take care not to expand
the end gap larger than required to slip the snap ring over the shaft. After installing a snap
ring, always ensure it Is completely seated in its groove and securely fitted.
* Use a torque wrench to tighten fasteners to the specified torque. Wipe off grease and oil if a
thread
Is smeared with them.
• After reassembling, check parts for tightness and proper operation.
• To protect the environment , do not unlawfully dispose of used motor oil , all other fluids , bat-
teries, and tires.
• To protect the earth's natural resources , properly dispose of used vehicles and parts.