Suzuki LT-Z400 - Cylinder Head Cover

3-62 ENGINE
• Install the dowel pins
1.
• Place each camshaft journal holders and cam chain guide
into the correct position.
NOTE:
Camshaft journal holders marked “EX” are for the exhaust side
and those marked “IN” are for the intake side.
• Tighten the camshaft journal holder bolts to the specified
torque.
# Camshaft journal holder bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
NOTE:
When tightening the camshaft journal holder bolts, the piston
position must be at TDC on the compression stroke.
CYLINDER HEAD COVER
• Thoroughly wipe off oil from the fitting surfaces of the cylinder
head and cover.
• Apply SUZUKI BOND “1207B” to the end caps of the cylinder
head cover gasket as shown.
* 99104-31140: SUZUKI BOND “1207B” (USA)
* 99000-31140: SUZUKI BOND “1207B” (Others)
• Apply engine oil to both sides of the washer
1.
• Lightly tighten the cylinder head cover bolts in diagonal
stages, and then tighten them to the specified torque.
# Cylinder head cover bolt
Initial: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
Final: 14 N·m (1.4 kgf-m, 10.0 lb-ft)
"
Use a new washers
1 and cushion 2.