3-52 ENGINE
GEARSHIFT CAM DRIVEN GEAR
• Tighten the gearshift cam driven gear bolt to the specified
torque.
# Gearshift cam driven gear bolt:
24 N·m (2.4 kgf-m, 17.5 lb-ft)
• Install each pawl lifter into the gearshift cam driven gear. The
large shoulder
A must face to the outside.
• Apply a small quantity of THREAD LOCK “1342” or THREAD
LOCK SUPER “1322” to the pawl lifter screws, and then
tighten them securely.
( 99000-32050: THREAD LOCK “1342” (USA)
, 99000-32110: THREAD LOCK SUPER “1322” (Others)
To Next Page
Loading...
