6-80 CHASSIS
REMOVAL
• Place the vehicle on the level ground and support the vehicle
with a jack or wooden block.
SPROCKET
• Remove the left rear wheel. (!6-10)
• Remove the left rear wheel hub. (!6-11)
• Remove the rear caliper.
• Loosen the chain adjust nuts
1 and the rear axle housing
bolts
2.
• Loosen the sprocket mounting bolts, and remove the sprocket
3.
REAR AXLE SHAFT
• Remove the rear wheels. (!6-10)
• Remove the rear wheel hubs. (!6-11)
• Loosen the axle nuts
1 with the special tool by applying the
rear brake.
• Remove the axle nuts and concave washers
2.
• Remove the sprocket flange
3.
& 09940-92450: Rear axle nut holder
• Remove the caliper.
• Draw out the rear axle shaft to the right.
• Remove the brake disc.
%
Do not attempt to remove the brake disc flange from
the rear axle shaft.
The rear axle shaft is available only as an assembly.
To Next Page
Loading...
